Marking Electronic Epoxy

Epoxy is widely known to burn and bubble under most Laser marking applications.  However, our MOPA design allows just the right energy to be applied to this material to create a high quality, legible mark.

Our range of redENERGY Pulsed Fiber Lasers can be used to lightly mark the black electronic grade epoxy used on a variety of components.

A Low Mode redENERGY L-type 20W Laser can be used to gently bleach the plastic leaving little surrounding burn or melt area. Creating an evenly marked surface that in many cases follows the texture contours of the moulded plastic.

Share article on...
Case Study

Product Solution – redENERGY

redENERGY G4

注册更新

If you enjoyed reading this article, why not register for future articles?

arrow