Linkedin Youku WeChat Weibo

Sorry, your browser is not compatible with some of the content on this website. Please update to a newer browser to view this website.

redPOWER Small Banner

Drilling Ceramic – Alumina

redENERGY G4 30W HS-S

Our range of redENERGY Pulsed Lasers can be used to drill 5 holes per second in 0.38mm alumina. The photo above shows the output side that is 75-80 microns in diameter. The input side is less than 100 microns in diameter.

LaserPower DemandBeam ØScanner/LensEnergy
 redENERGY G4 30W HS-S 30W1.211mm14mm aperture /100mm F- thetaWF0 0.65mJ @45kHz

Our range of redENERGY Pulsed Lasers can be used to drill 5 holes per second in 0.38mm alumina. The photo above shows the output side that is 75-80 microns in diameter. The input side is less than 100 microns in diameter.

These holes have been made using a beam wobbling technique to control hole diameter and quality. Our redENERGY Single Mode S-type Laser is an excellent tool for such drilling because it can perform this task with a range of spot sizes from 15 to 20 microns. The high beam quality gives exceptional depth of field for processing allowing the use of larger marking fields or smaller scan heads to complete the task.

A wobble of 1000Hz at a 40 micron radius was applied to a circular path 0.08mm in diameter. This was repeated 40 times in under 200ms.  The 30W S-Type laser produces 0.65mJ at 45kHz.

Excessive heating was reduced by offsetting the holes by 0.5mm and then returning to fill in the holes at 0.25 mm spacing shown.

Smaller holes, with a 20 micron output can be created in this material considerably faster.

To download this Applications Postcard as a PDF click here!

Share article on...

注册更新

If you enjoyed reading this article, why not register for future articles?

arrow
CONTACT ME CONTACT ME