전자 장치

광섬유 레이저는 전자 장치 생산에 중요한 도구입니다. 자동화 제조 시스템에 쉽게 통합할 수 있으며, 전자 산업 분야에서 필요한 정교하고 신뢰할 수 있는 용접을 달성할 수 있습니다.

당사 레이저는 마이크로칩 마킹에서 절삭 전자 스텐실에 이르기까지 전자 산업의 다양한 분야에 사용할 수 있습니다.  광섬유 레이저는 어떠한 도전 과제에도 탁월한 수준의 혁신적인 가공 처리 기술을 제공합니다.

Although the technology for additive manufacturing has been around for much longer than many people realise, it’s an industry which is still relatively in its infancy.Additive manufacturing is now being used in a number of different... read more >

Case Study

Marking Electronic Epoxy

Posted on 06/11/2015

Epoxy is widely known to burn and bubble under most Laser marking applications.  However, our MOPA design allows just the right energy to be applied to this material to create a high quality, legible mark.Our range of redENERGY Pulsed Fiber... read more >

Disk Drive Flexure Welding

Posted on 06/11/2015

Disk drive flexures hold the ferrite reader that floats over the spinning magnetic media in a hard drive.The high speeds of positioning and the ultra-close proximity of the ferrite reader mean the flexures must be accurately assembled from 3 or... read more >

Having worked with all major telecoms suppliers to achieve the precision Laser welding required for these devices, including the development of special pulse shapes, we are perfectly positioned to use our skills and expertise to assist any... read more >

The successful manufacture of electronic printed circuit board assemblies relies on the precise dispensing of solder paste through a stencil.Once the solder paste is deposited, the components are placed onto the paste and the whole assembly is... read more >

Case Study

Component Marking

Posted on 06/11/2015

Lasers are one of the most reliable methods of direct part marking. They can easily achieve high contrast details, enabling the traceability of almost any product.The clean, high quality, permanent marks obtained with a Laser are durable... read more >

Battery Welding

Posted on 06/11/2015

Batteries require careful assembly to create a safe, convenient and powerful device. Most consumer batteries use crimped metal seals with a polymer sealant for their packaging. However, when the cell's chemistry changes or more components must be... read more >

Case Study

Sensor Welding

Posted on 06/11/2015

Sensor assembly requires some very high technology in both sensing technology and packaging to create a robust, small, and accurate system that can survive in a hostile environment. In the past these sensors could be larger and employ gaskets or... read more >

Case Study

Sintering Printed Circuits

Posted on 06/11/2015

Many large area electronic display panels require metal conductors and busbars, today printing and patterning takes place to create connections.Our redENERGY G4 pulsed Laser can be used in both CW and pulsed modes to sinter/cure the printed... read more >