|Laser||Power Demand||M²||Beam Ø||Scanner/Lens||Energy|
|redENERGY G4 20W EP-L||20W||<2||6.1mm||10mm aperture /163mm F- theta||WF31 3ns @150kHz|
Many consumer electronic goods are manufactured from white plastic, and some have a clear hard coating applied. Achieving a smooth mark on this type of plastic can be difficult to achieve with a standard ns pulsed Laser, since it is easy to melt the hard-coat layer.
Trials have shown that a good mark can be achieved using a short Pulse Laser operating at a relatively low frequency. The sample shown was produced using a 3ns pulse with a scan speed of 500mm/s at a frequency of 150kHz, and the result is a smooth mark which has a uniform appearance.
It is important to optimise the line to line hatch spacing and scanner synchronisation delays in order to achieve this type of mark.
The workstation used a 75mm BEC which produced an 8.1mm (1/e2) diameter beam at the scanner entrance, allowing a 10mm aperture scanner to be used. The scanner was fitted with a 163mm focal length objective lens which gave a 110x110mm field size.
FÜR NEUIGKEITEN REGISTRIEREN
If you enjoyed reading this article, why not register for future articles?