|Laser||Power Demand||M²||Beam Ø||Scanner/Lens||Energy|
|redENERGY G4 30W HS-S||30W||1.2||11mm||14mm aperture /100mm F- theta||WF0 0.65mJ @45kHz|
Our range of redENERGY Pulsed Lasers can be used to drill 5 holes per second in 0.38mm alumina. The photo above shows the output side that is 75-80 microns in diameter. The input side is less than 100 microns in diameter.
redENERGY Single Mode S-type Laser
These holes have been made using a beam wobbling technique to control hole diameter and quality. Our redENERGY Single Mode S-type Laser is an excellent tool for such drilling because it can perform this task with a range of spot sizes from 15 to 20 microns. The high beam quality gives an exceptional depth of field for processing allowing the use of larger marking fields or smaller scan heads to complete the task.
A wobble of 1000Hz at a 40 micron radius was applied to a circular path 0.08mm in diameter. This was repeated 40 times in under 200ms. The 30W S-Type laser produces 0.65mJ at 45kHz.
Excessive heating was reduced by offsetting the holes by 0.5mm and then returning to fill in the holes at 0.25 mm spacing shown.
Smaller holes, with a 20 micron output can be created in this material considerably faster.
Contact SPI Lasers to Discuss Laser Drilling Ceramic and Other Topics
Call us on +44(0)1489 779696 to discuss laser drilling and other laser applications enabled through our products. If you prefer you can complete our contact form here. Subscribe to receive regular SPI Lasers updates via this link.
FÜR NEUIGKEITEN REGISTRIEREN
If you enjoyed reading this article, why not register for future articles?