Ceramic Scribing

The technique of scribing engineering ceramics such as silicon nitride or alumina involves a groove being cut into the material, the width of which can be controlled. The material can then be broken along this groove. This leaves a high quality edge finish with minimal micro-fracturing. Furthermore, as there is only a small amount of material being ablated, processing times can be minimised. Alumina is the most common engineering ceramic that requires this application. An example of its use is in singulated LED circuits.

Our G4 70W EP-Z laser was able to scribe lines in silicon nitride with a width of at least 30μm and a depth of >80μm at 200mm/s with just one single pass. Longer pulse duration (WF 36 /520ns) provides deeper scribes at a constant scan speed compared to shorter pulse durations. However, using multiple passes with long and short pulse durations, scribe depth can be increased and the scribe profile can be improved. With the G4 laser, rapid changing of pulse parameters can be done on the fly.

Longer pulse durations were shown to provide deeper scribes at a constant scan speed when compared to shorter pulse durations. Furthermore, a wobble can be applied to achieve a high quality scribe with a width greater than 30µm and a depth of >80μm. Similar scribing results can be achieved on a range of other engineering ceramics.

Share article on...

Application Parameters

TypeG4 70W EP- Z
Power Demand70W
M2<1.6
Beam Ø8mm
Scanner/Lens15mm/100mm FL
EnergyWF36 70kHz @200mm/s

Related Product – redENERGY

redENERGY G4

FÜR NEUIGKEITEN REGISTRIEREN

If you enjoyed reading this article, why not register for future articles?

arrow