Sorry, your browser is not compatible with some of the content on this website. Please update to a newer browser to view this website.

redPOWER Small Banner

Ceramic Cutting

redENERGY G4 100W EP-Z

Aluminium Nitride (AlN) has been developed into a commercially viable product with many useful mechanical properties.

LaserPower DemandBeam ØScanner/LensEnergy
 redENERGY G4 50W EP-Z 50W<1.6 8mm >8mm/163mm F-ThetaWF0 50kHz @ 400mm/s

Aluminium Nitride (AlN) has been developed into a commercially viable product with many useful mechanical properties. These properties include one of the highest thermal conductivities of any engineering ceramic and a thermal expansion coefficient almost half that of alumina. AlN ceramic is used widely in the electronics industry because of its thermal conductivity and ability to be used as an electrical insulator, meaning the material is often used as a heat sink.

Aluminium nitride is hard and brittle, which makes it difficult to process with conventional machining methods. Our G4 50W EP-Z laser shows that it is possible to achieve high quality edges with the use of long pulse durations and low scanning speeds. The challenge with this application is that the material cannot absorb high amounts of energy without melting or vaporising due to its heat conducting properties.

Higher power lasers can be used to reduce process time without compromising edge quality, due to the materials high thermal conductivity. Using a fiber laser also allows AlN ceramic to be cut in its green state before the material is fired.

The process produces a very high quality cut and although not essential, post processing is recommended to enhance the quality yet further. Drilling and engraving of Ceramic is also possible with equally high quality and effective processing.

To download this Applications Postcard as a PDF click here!

Share article on...
Ceramic Cutting

REGISTER FOR UPDATES

If you enjoyed reading this article, why not register for future articles?

arrow
CONTACT ME CONTACT ME